Installing a dishwasher:
Firstly follow instructions under heading Wingbacks set out for a new kitchen and dishwasher: Then drill a 2 inch (50 mm) wood saw hole in the corner of your sink cupboard next to the wall where the dishwashers back connections are. Then drill another hole the same size next to and below this hole inside the cavity for the dishwasher.
Now fit a ¾-inch (20 mm) by ½-inch (15 mm) female dishwasher tap to the end of the male barrel nipple underneath inside the sink cupboard.
Next take a waste pipe dishwasher nipple trap and place it up against the plug and waste on the new sink bowl. And connect the outlet of the trap to the waste pipe by way of bends or a straight coupling and PVC solvent cement.
Next slide the dishwasher over near its spot and feed the electric plug through the two holes you cut earlier. Then follow this up with the water hose connection and finally the drain hose. All through into the cupboard as you push in the dishwasher bit by bit.
Hook up water connection hose to dishwasher tap and connect drain hose into nipple on trap making sure this nipple does not have to be drilled out that it is already clear. Next fit the U-shaped bend onto the drain hose and screw up under the sink bowl nice and high to prevent siphoning out.