The pedal set in the DUBINA EVO consists of three pedals. Left parking brake pedal, center brake pedal, right current pedal. The pedals are made of structural aluminum alloy. On the pedals, the position of the pedal plates, the angle of inclination, spring rate. The current and brake pedals are electronic. They are controlled through a central microcontroller. When the brake pedal is depressed, the shaft and the magnet move simultaneously. Magnetic sensors on the printed circuit board, the length of the movement of the magnet is detected and output signals for the microcontroller are provided. The microcontroller processes the signals and controls the motors. Magnetic sensor pedals are highly accurate and reliable because they do not have rubbing parts subject to wear. The parking brake is mechanical. When you press the parking brake pedal, the steel cable pulls out the stopper, which falls into the groove of the gear, mounted on the drive shaft, and stops it. The pedals are mounted on the cockpit floor for ease of use. The size of the pedal unit is 43x43x28 cm.
